How to Recover Data from Solid State Drive
(Photo : How to Recover Data from Solid State Drive )

Solid State Drive or SSD is secondary storage in the hierarchy of computer storage. SSD uses integrated circuits to store data and lacks physical rotating discs as in HDD. Although Solid State Drives are resistant to physical shock, problems with the drives are not rare.

SSD in combination with HDD has been used in computers for optimized performance. Solid-State Hybrid Drives (SSHD) are slightly notched up from the previous combination. Corrupted SSDs can potentially resist SSD data recovery. The following reasons can be the cause of your distress.

Part 1: Common situations of SSD card failure

Contrary to traditional HDD, SSDs have no moving parts. Hence, the latter is exempted from mechanical problems. It is not wise to assume that the drive will be flawless. Some potential reasons for a corrupted or dead SSD are:

1. Data Corruption 

System files on the drive or other files are not immune to malware and viruses. Once infected, they result in undesirable logical operations leading to SSD failure. The effect that surfaces itself is the data loss from your drive.

2. Faulty Circuits 

As the SSD uses integrated circuits to store data, a minute soldering error can cause a short circuit. This in turn allows heavy current to flow to sensitive components and quite literally "frying" the drive from inside out.This problem is better left for experts to handle as you can cause more harm than good while soldering by yourself. The worst-case scenario being data recovery from SSD is impossible.

3. Firmware Upgrade

Any electronic component running with software requires a system upgrade. During the installation of Drive Firmware Updates, if the process is interrupted in the slightest, results in system malfunction. Sudden failure in normal operations of SSD is the result.

Fixing a corrupted or dead Solid State Drive can be tricky but not impossible. Before turning to professional aid, there are some plausible fixes you can try to overcome this hitch.

Part 2: How to Fix a Dead SSD

Before trying the advanced fixes, occasionally simple steps are enough to solve your problem. Sometimes, you need not worry about SSD data recovery as few solutions can get rid of the problem for you. Some of the useful DIY tips are as follows:

1. Manual Booting

Step 1: Turn off the computer and unplug the SATA cable from the SSD.

Step 2: Leaving the power cable connected, switch on the computer.

Step 3: Enter into BIOS mode and let it sit idly for 20 to 30 minutes.

Step 4: Turning off the computer, plug the SATA cable in the SSD.

Step 5: Once again, switching on the computer, navigate to Boot Setup Menu and set it to Boot from SSD.

Step 6: Now check if your system recognizes the SSD.

2) Update SSD drivers

Functional SSDs over the years develop bugs or their drivers become obsolete in comparison to the current system. Updating device drives are important for glitch-free performance. To update drivers in a Windows environment.

Step 1: Press Windows + X key and select Device Manager from the menu.

Step 1: Press Windows + X key and select Device Manager from the menu.

Step 2: Select the Disc Drives section to expand the available drives.

Step 2: Select the Disc Drives section to expand the available drives.

 Step 3: Right-click on the SSD device and select Update Driver.

 Step 3: Right-click on the SSD device and select Update Driver.

Step 4: Now follow the displayed instructions to update.

3) Bad Sectors 

In a Hard Disk Drive or HDD, bad sectors predict a failure in the drive. However, the nature of flash technology has a small number of it. There is a way to check whether the number of bad sectors is constant or increasing over time.

In the case of Windows, open the command prompt and type "run ChkDsk". This output the number of bad sectors on the drive you selected. Repeat the same after a few days. If the number remains the same, you need not worry. If the number gradually increases, it is time to replace the Solid State Drive.

Part 3: How to Recover Data from Dead SSD

The above steps hopefully should solve the issue. If none of them seems to work, professional aid is the last resort. However, you have a faint ray of hope to recover your data from the SSD before sending it to get repaired. Wondershare Recoverit, offers one of the most comprehensive data recovery from SSD.

Recoverit is a flagship software in the data recovery market that has more than 5 million users over the globe. Supported over various systems like Windows, Mac, this can extract any or all of the data despite the file formats.

The simple steps to recover data in no time are described elaborately below.

Step 1: Connecting the External Device

Download the setup file for your system. After installation, launch Recoverit. Before proceeding, make sure to connect your external drive to the PC.

Step 2: Selecting the External Device 

To extract data from SSD, i.e. external device, select External Devices Recovery.From the list of Drives displayed, select SSD device and click Start to scan for lost data files.

Step 2: Selecting the External Device

Step 3: Scan the External Device

The software launches a scan to search for recoverable data. Generally, the desired files are shown. If you think that all of your data is not displayed, you can opt for All-around Recovery.

Step 3: Scan the External Device

Step 4: Preview and Recover the Files 

Now preview your files and click on Recover.It is advised to temporarily store the recovered data in a different location until the SSD is repaired.

Step 4: Preview and Recover the Files

Now you can breathe a sigh of relief as you have obtained the useful, recoverable data. The rest is best to be left with experts.


Solid State Drives have optimized computer system performance to a great deal. Hopefully, the above steps were sufficient to troubleshoot and fix the issues. Wondershare's Recoverit is SSD data recovery the best software one can get.

ⓒ 2021 All rights reserved. Do not reproduce without permission.